Spindle -replacement-part-1
Apr 08, 2026 12:03
· 0:56
· English
· Whisper Turbo
· 2 Hökmdar
Bu transkriptin müddəti bu gün bitəcək.
Daimi saxlama üçün yüksəlt →
Yalnız göstər
0:05
S…
Speaker 1 (Spindle -replacement-part-1)
This procedure will show you how to replace a 40 taper inline spindle in a mill.
0:09
S…
Speaker 1 (Spindle -replacement-part-1)
Just make sure you understand why the previous spindle failed before you install the new one.
0:17
S…
Speaker 1 (Spindle -replacement-part-1)
Disconnect the spindle lubrication tube.
0:22
S…
Speaker 1 (Spindle -replacement-part-1)
Remove the spindle lube fitting.
0:27
S…
Speaker 1 (Spindle -replacement-part-1)
If you find it difficult to remove the lube fitting, you can skip ahead and remove the protective cap from the replacement spindle and install it on the old one.
0:34
S…
Speaker 1 (Spindle -replacement-part-1)
This cap will protect the spindle during replacement.
0:37
S…
Speaker 1 (Spindle -replacement-part-1)
Remember that failed warranty spindles will be analyzed at the factory.
0:41
S…
Speaker 1 (Spindle -replacement-part-1)
They need to be protected and removed with care so the true cause of failure can be determined.
0:47
S…
Speaker 2 (Spindle -replacement-part-1)
Loosen the spindle bolts a few turns.
0:51
S…
Speaker 1 (Spindle -replacement-part-1)
Jog the z-axis in a negative direction until the spindle touches the table or a flat block.
Bu transkript AI (avtomatik səs tanıması) tərəfindən yaradılmışdır. Xətalar ola bilər - kritik istifadə üçün orijinal səslə müqayisə edin. AI siyasəti
İcmal
Bu transkriptin AI qısa mə'lumatını yaratmaq üçün Summarize düyməsini basın.
İcmallaşdırılır...
Bu transkript haqqında AI-dən soruş
Bu transkript haqqında hər şeyi soruşun — AI uyğun hissələri tapacaq və cavab verəcək.