Spindle -replacement-part-1
Apr 08, 2026 12:03
· 0:56
· English
· Whisper Turbo
· 2 Speakers
Henda útgávan er útgivin í dag.
Uppgradering til permanent lagring →
Showing only
0:05
S…
Speaker 1 (Spindle -replacement-part-1)
This procedure will show you how to replace a 40 taper inline spindle in a mill.
0:09
S…
Speaker 1 (Spindle -replacement-part-1)
Just make sure you understand why the previous spindle failed before you install the new one.
0:17
S…
Speaker 1 (Spindle -replacement-part-1)
Disconnect the spindle lubrication tube.
0:22
S…
Speaker 1 (Spindle -replacement-part-1)
Remove the spindle lube fitting.
0:27
S…
Speaker 1 (Spindle -replacement-part-1)
If you find it difficult to remove the lube fitting, you can skip ahead and remove the protective cap from the replacement spindle and install it on the old one.
0:34
S…
Speaker 1 (Spindle -replacement-part-1)
This cap will protect the spindle during replacement.
0:37
S…
Speaker 1 (Spindle -replacement-part-1)
Remember that failed warranty spindles will be analyzed at the factory.
0:41
S…
Speaker 1 (Spindle -replacement-part-1)
They need to be protected and removed with care so the true cause of failure can be determined.
0:47
S…
Speaker 2 (Spindle -replacement-part-1)
Loosen the spindle bolts a few turns.
0:51
S…
Speaker 1 (Spindle -replacement-part-1)
Jog the z-axis in a negative direction until the spindle touches the table or a flat block.
This transcript was generated by AI (automatic speech recognition). May contain errors - check against the original audio for critical use. Politikkur
Samandráttur
Click Summarize to generate an AI summary of this transcript.
Summating...
Spørg AI um hetta transkriptión
Tað er ein spurningur um, hvussu nógvar ferðir ein kann skriva og lesa.