Spindle -replacement-part-1
Apr 08, 2026 12:03
· 0:56
· English
· Whisper Turbo
· 2 Ke Keiki
E pau kēia hoʻoili i kēia lā.
Hoʻonui no ka mālama mau →
Hōʻike wale
0:05
S…
Speaker 1 (Spindle -replacement-part-1)
This procedure will show you how to replace a 40 taper inline spindle in a mill.
0:09
S…
Speaker 1 (Spindle -replacement-part-1)
Just make sure you understand why the previous spindle failed before you install the new one.
0:17
S…
Speaker 1 (Spindle -replacement-part-1)
Disconnect the spindle lubrication tube.
0:22
S…
Speaker 1 (Spindle -replacement-part-1)
Remove the spindle lube fitting.
0:27
S…
Speaker 1 (Spindle -replacement-part-1)
If you find it difficult to remove the lube fitting, you can skip ahead and remove the protective cap from the replacement spindle and install it on the old one.
0:34
S…
Speaker 1 (Spindle -replacement-part-1)
This cap will protect the spindle during replacement.
0:37
S…
Speaker 1 (Spindle -replacement-part-1)
Remember that failed warranty spindles will be analyzed at the factory.
0:41
S…
Speaker 1 (Spindle -replacement-part-1)
They need to be protected and removed with care so the true cause of failure can be determined.
0:47
S…
Speaker 2 (Spindle -replacement-part-1)
Loosen the spindle bolts a few turns.
0:51
S…
Speaker 1 (Spindle -replacement-part-1)
Jog the z-axis in a negative direction until the spindle touches the table or a flat block.
I hana ʻia kēia transcript e AI (hoʻomaopopo leo mau). Hiki ke loaʻa nā hewa — e hōʻoia i ka leo mua no ka hoʻohana nui. Ka'ōlelo aʻo AI
Hōʻuluʻulu
Kaomi Summarize e hana i ka AI mahele o kēia transcript.
E hōʻuluʻulu ana...
E nīnau i ka AI e pili ana i kēia transcript
E nīnau i kekahi mea e pili ana i kēia transcript - e loaʻa ana ka AI i nā ʻāpana pili a me ka pane.