Spindle -replacement-part-1
Apr 08, 2026 12:03
· 0:56
· English
· Whisper Turbo
· 2 Høyttalere
Denne utskriften utløper i dag.
Oppgradering for permanent lagring →
Viser bare
0:05
S…
Speaker 1 (Spindle -replacement-part-1)
This procedure will show you how to replace a 40 taper inline spindle in a mill.
0:09
S…
Speaker 1 (Spindle -replacement-part-1)
Just make sure you understand why the previous spindle failed before you install the new one.
0:17
S…
Speaker 1 (Spindle -replacement-part-1)
Disconnect the spindle lubrication tube.
0:22
S…
Speaker 1 (Spindle -replacement-part-1)
Remove the spindle lube fitting.
0:27
S…
Speaker 1 (Spindle -replacement-part-1)
If you find it difficult to remove the lube fitting, you can skip ahead and remove the protective cap from the replacement spindle and install it on the old one.
0:34
S…
Speaker 1 (Spindle -replacement-part-1)
This cap will protect the spindle during replacement.
0:37
S…
Speaker 1 (Spindle -replacement-part-1)
Remember that failed warranty spindles will be analyzed at the factory.
0:41
S…
Speaker 1 (Spindle -replacement-part-1)
They need to be protected and removed with care so the true cause of failure can be determined.
0:47
S…
Speaker 2 (Spindle -replacement-part-1)
Loosen the spindle bolts a few turns.
0:51
S…
Speaker 1 (Spindle -replacement-part-1)
Jog the z-axis in a negative direction until the spindle touches the table or a flat block.
Denne utskrifta ble laget av AI (automatisk talegjenkjenning). Kan inneholde feil – sjekk mot den opprinnelige lyden for kritisk bruk. AI- praksis
Sammendrag
Trykk Summarize for å lage et AI- sammendrag av denne utskrifta.
Summarerer...
Spør AI om dette transkriptet
Spør noe om denne utskrifta – AI- en vil finne relevante avsnitt og svar.