Spindle -replacement-part-1
Apr 08, 2026 12:03
· 0:56
· English
· Whisper Turbo
· 2 वक्ता:
एतत् लिखितं पत्रं आजम् समाप्तं भवति ।
अद्यतनीकरणं स्थायी भण्डारणार्थम् →
केवलं दर्शयति
0:05
S…
Speaker 1 (Spindle -replacement-part-1)
This procedure will show you how to replace a 40 taper inline spindle in a mill.
0:09
S…
Speaker 1 (Spindle -replacement-part-1)
Just make sure you understand why the previous spindle failed before you install the new one.
0:17
S…
Speaker 1 (Spindle -replacement-part-1)
Disconnect the spindle lubrication tube.
0:22
S…
Speaker 1 (Spindle -replacement-part-1)
Remove the spindle lube fitting.
0:27
S…
Speaker 1 (Spindle -replacement-part-1)
If you find it difficult to remove the lube fitting, you can skip ahead and remove the protective cap from the replacement spindle and install it on the old one.
0:34
S…
Speaker 1 (Spindle -replacement-part-1)
This cap will protect the spindle during replacement.
0:37
S…
Speaker 1 (Spindle -replacement-part-1)
Remember that failed warranty spindles will be analyzed at the factory.
0:41
S…
Speaker 1 (Spindle -replacement-part-1)
They need to be protected and removed with care so the true cause of failure can be determined.
0:47
S…
Speaker 2 (Spindle -replacement-part-1)
Loosen the spindle bolts a few turns.
0:51
S…
Speaker 1 (Spindle -replacement-part-1)
Jog the z-axis in a negative direction until the spindle touches the table or a flat block.
अस्मिन् ध्वनिमुद्रणे AI (आटोमेटिक स्पीच रिकग्निशन) द्वारा निर्मितः अस्ति । त्रुटिः वर्तते । अतः त्रुटिः वर्तते । अतः त्रुटिः वर्तते । AI नीतिः
सारांशः
सम्पादयतु
सम्पादयतु...
ॐ ऐं ह्रीं
यदा यदा कस्यापि विषये प्रश्नः भवति, तदा यन्त्रं तत्संबंधितं भागं सूचयति, तथा उत्तरं प्रदत्तं भवति ।