Spindle -replacement-part-1
Apr 08, 2026 12:03
· 0:56
· English
· Whisper Turbo
· 2 Àwọn Àkọ́lé
Àwọn àkọlé yìí tí wọ́n tì kù.
Àwọn ìṣàfihàn fún àwọn àwọn ààyè-iṣẹ́ ìdájọ →
Fihàn
0:05
S…
Speaker 1 (Spindle -replacement-part-1)
This procedure will show you how to replace a 40 taper inline spindle in a mill.
0:09
S…
Speaker 1 (Spindle -replacement-part-1)
Just make sure you understand why the previous spindle failed before you install the new one.
0:17
S…
Speaker 1 (Spindle -replacement-part-1)
Disconnect the spindle lubrication tube.
0:22
S…
Speaker 1 (Spindle -replacement-part-1)
Remove the spindle lube fitting.
0:27
S…
Speaker 1 (Spindle -replacement-part-1)
If you find it difficult to remove the lube fitting, you can skip ahead and remove the protective cap from the replacement spindle and install it on the old one.
0:34
S…
Speaker 1 (Spindle -replacement-part-1)
This cap will protect the spindle during replacement.
0:37
S…
Speaker 1 (Spindle -replacement-part-1)
Remember that failed warranty spindles will be analyzed at the factory.
0:41
S…
Speaker 1 (Spindle -replacement-part-1)
They need to be protected and removed with care so the true cause of failure can be determined.
0:47
S…
Speaker 2 (Spindle -replacement-part-1)
Loosen the spindle bolts a few turns.
0:51
S…
Speaker 1 (Spindle -replacement-part-1)
Jog the z-axis in a negative direction until the spindle touches the table or a flat block.
Àkọ́lé yìí láti inú AI (ìdákọ́ àwọn àkọ́lé nípa ìṣàfarawé). O lè ní àwọn àṣìṣe - ṣàyẹwo àwọn àwòrán ìṣàmúlò-ètò fún ìlòòrò. Àwọn ìtàn
Àwọn Àkọlé
Tẹ̀ Àwọn Àkọ́gbègbè láti ṣẹ̀dá àwọn àkọ́gbègbè AI tí a kọ́ nípa àkọ́gbègbè yìí.
Àwọn àwọn àkọlé...
Ǹgbàyé AI Àwọn Àkọ́kọ́
Fọ̀rọ̀ ohunkohun nipa àkọ́kọ́ yìí — AI náà yóò bá a lè ri àwọn ààyè tí a fẹ́ ki o si dáwọ́.