Showing only
0:03
S… Speaker 2 (Spindle-replacement-part-2)
Remove the spindle screws.
0:06
S… Speaker 1 (Spindle-replacement-part-2)
At this point, if you have not yet removed the spindle loop fitting,
0:09
S… Speaker 1 (Spindle-replacement-part-2)
you can rotate the spindle so you have better access to the fitting.
0:17
S… Speaker 1 (Spindle-replacement-part-2)
Install a 1 1⁄8 MPT plug below flush with the surface of the spindle
0:21
S… Speaker 1 (Spindle-replacement-part-2)
or use the rubber plug from the replacement spindle.
0:24
S… Speaker 1 (Spindle-replacement-part-2)
Rotate the spindle back to its original position
0:26
S… Speaker 1 (Spindle-replacement-part-2)
and jog the z-axis up slowly to remove the spindle.
0:34
S… Speaker 1 (Spindle-replacement-part-2)
Make note of any shim locations and remove the shims.
0:39
S… Speaker 1 (Spindle-replacement-part-2)
If your machine uses a coupler,
0:41
S… Speaker 1 (Spindle-replacement-part-2)
remove the spider coupling to be reused with the new spindle.
0:43
S… Speaker 2 (Spindle-replacement-part-2)
Remove the coolant transfer tube.
0:46
S… Speaker 1 (Spindle-replacement-part-2)
Sometimes these parts stay in the motor.
0:52
S… Speaker 1 (Spindle-replacement-part-2)
Attach the red protective cap to the new spindle
0:54
S… Speaker 1 (Spindle-replacement-part-2)
and the lube port plug if you removed it earlier.
0:58
S… Speaker 1 (Spindle-replacement-part-2)
Clean and stone the spindle head surface and the new spindle's flange.
1:03
S… Speaker 1 (Spindle-replacement-part-2)
Apply a thin layer of lithium grease to the transfer tube o-rings,
1:06
S… Speaker 1 (Spindle-replacement-part-2)
the spider coupler or dry pin bushings,
1:09
S… Speaker 2 (Spindle-replacement-part-2)
and the lower spindle o-ring.

This transcript was generated by AI (automatic speech recognition). May contain errors - check against the original audio for critical use. Politikkur

❤️ Love STT.ai? Tell your friends!
Samandráttur
Click Summarize to generate an AI summary of this transcript.
Summating...
Spørg AI um hetta transkriptión
Tað er ein spurningur um, hvussu nógvar ferðir ein kann skriva og lesa.